The principle of bending wood is you have to get it up to a high temperature at which point the glues that hold the fibres together melt allowing the fibres to slide over each other. As it cools the fibres set in their new position. It takes a long time to heat up and a short time to cool down so there are several hours of anticipation followed by a few minutes of stress, bending days are fun. There is evidence for Bronze age wood bending both in surviving boat timbers including those of the Dover Boat and also there are apparently also sites alongside water where tons of pot boilers (burnt rocks) have been found. Hot rocks can be used to steam large boat timbers as in this slide show of a NWC dug out http://www.haidanation.ca/Pages/Splash/PhotoGallery/canoe_steaming.html
It would have been fun to experiment with different possible Bronze Age heating methods but the budget does not allow for that and we have plenty of other variables to experiment with so we are using 21st century heating. This is our first steaming set up, made from 2" polystyrene, we have since replaced it with high density cellotex insulation board which lasts better with the heat.
the steam is provided by a bank of wallpaper steamers with another on preheat ready to keep the temperature up. Keeping these topped up is a full time job for 3 hours. Crucially we also have various temperature probes to let us know the temperature inside the cabinet and in the centre of our piece of wood.
With our early steams there was lots of nervous checking and packing to keep steam from escaping, we now have it well sorted and are running at slight pressure in the chamber giving us over 100 degrees.
This image shows my side timbers one steamed and the other as carved, it's hard to show the degree of the three dimensional curve in a photo but it is remarkable and astonishing that folk were doing this 3,500 years ago, it really is complex stuff.
We are genuinely feeling our way with this project and for every step forward there is a lot of head scratching, planning and forethought. It is beginning to come together nicely now though.
We are now on a very welcome 4 day Easter break but this is what the boat looks like now. The next stage is cutting the joints and stitching the planks together with twisted yew withies, marking out for the top planks, bending up the base planks to match the side planks and cutting the infill pieces for the ends. It is meant to be launched on May 5th and to stand any chance of that we will be working very hard. There may be an opportunity for one or two skilled volunteers to join us over this period so if you can get time off and want to be involved in a great woodworking project get in touch. Most of the work will be lifting and carrying during steaming and lots of cutting stitch holes with bronze tools, I think we have around 600 to do.
Just as a comparison this is the original 3,500 year old boat in the museum alongside where we are working. I used to think the Mary Rose was special, this boat was down there 7 times as long and had already been buried 1500 years when the Romans arrived. It is the oldest surviving sea going vessel anywhere in the world and hardly anyone knows about it. To be building a copy of it and have access to see the original close too is a very special experience.